Glad to here it is still living on in one form or another!

Mark

I've stripped my spare engine and listed the parts on Ebay.

Search for XU9J4 for a quick search.

I still have a set of four doors, drive shafts, front and rear suspension struts, power steering rack, rear bumper and tailgate.

Mark

When I put the Kent cams in mine it always ran hot. I too had to put the blowers on when stood in traffic. An easy fix which worked great, was to fit a second cooling fan controlled from a switch in the cabin. I positioned mine at the side of the front fog-light switch. There are already mounting ...

I once had a similar problem, good spark, good fuel supply, fully charged battery but it just wouldn't start. It would try now and then but wouldn't keep going. It turned out to be the Crank Angle Sensor (CAS), which is an inductive pick up sensor fitted in the top of the clutch bellhousing. It ...

I have two heads stripped down and I am selling all parts. Timmo may be having one set of valves but everything else is available. I'll do a bare head for £30 and other parts at decent prices. P&P based on weight.

Mark.

Timmo, I'll do you the valves/collets (and springs if you want) for £20 or £2 each if you don't want them all. P&P will depend on weight. I take it you will get them re-cut and lapped?

Mark.

If your after bits from a head I still have a complete head and also a head fully stripped, so will be selling bits individually. I also have a bottom end fully stripped with decent rings & liners.

I can sort you out with the stat housing.

Are the phase 1 doors the same as the phase 2 doors? I have some grey doors off a phase 2.

Mark.

Due to the length of the demister panel (1.4m) the cheapest courier I could find was Fedex, they want £90 (not sure if there is vat on that without filling the forms in).

The demister panel is plastic welded to the main dash panel, so you would have to re-melt or glue it to your dash.

Regards ...

Best postage costs I can find for the Netherlands is £18 for the headrests or £45 for the headrests and the cylinder head (assuming the parcel does not go over 50kg).

Let me know what you would like?

Regards,
Mark.

The tappets were not from Citroen. They were from are reputable engine rebuilders in Sheffield (Beckett and Garner) where I had all my head work done. They have done less than 500miles.

Mark

Hi Oldred

No it's just the Bosch ECU.

I've had a quick look and I do have the loom with the round connector that supplies the injectors/aux air valve. Also I have the loom with the rectangular white connectors that supply the temp sensors.

Sensor wise I have an air flow meter. I should have the ...

Here is a list of some of the spares; (note, some of the items I have 2 of (x2))

Engine block with recent re-hone of bores+rings, recent big-end shells. £50
Complete cylinder head. £45 (x2)
Inlet manifold with fuel rail/throttle body/coil. £30
Another throttle body. £10 - SOLD
Exhaust manifold. £10 ...

I did view on Saturday morning: Mark's a nice bloke and the car was nice but not for me.

Mike P.

Cheers Mike, it is good to put a face to a name!

A guy from Liverpool came over yesterday and went for it. It's 'ste s', he put a request in the wanted section for a Ph2 last week. Hopefully it ...

My car has now been sold.

I still have loads of spares. I will try to get some prices onto the list.

BazGTMi, pm sent.

Mark